Homeco Energy Ground source heat pumps
A Homeco Energy Ground source heat pump uses pipes which are buried in the garden to extract heat from the ground. This heat can then be used to heat radiators, underfloor or warm air heating systems and hot water in your home.
A ground source heat pump circulates a mixture of water and antifreeze around a loop of pipe - called a ground loop - which is buried in your garden. Heat from the ground is absorbed into the fluid and then passes through a heat exchanger into the heat pump. The ground stays at a fairly constant temperature under the surface, so the heat pump can be used throughout the year - even in the middle of winter.
The length of the ground loop depends on the size of your home and the amount of heat you need. Longer loops can draw more heat from the ground, but need more space to be buried in. If space is limited, a vertical borehole can be drilled instead.
The benefits of ground source heat pumps
- lower fuel bills, especially if you replace conventional electric heating
- could provide you with an income through the government´s Renewable Heat Incentive (RHI)
- lower your home´s carbon emissions, depending on which fuel you are replacing
- don't need fuel deliveries
- can heat your home and provide hot water
- need little maintenance - they're called ‘fit and forget´ technology.
Unlike gas and oil boilers, heat pumps deliver heat at lower temperatures over much longer periods. During the winter they may need to be on constantly to heat your home efficiently. You will also notice that radiators won't feel as hot to the touch as they might do when you are using a gas or oil boiler.
Heat from the ground is absorbed at low temperatures into a fluid inside a loop of pipe (a ground loop) buried underground. The fluid then passes through a compressor that raises it to a higher temperature, which can then heat water for the heating and hot water circuits of the house. The cooled ground-loop fluid passes back into the ground where it absorbs further energy from the ground in a continuous process as long as heating is required.
Normally the loop is laid flat or coiled in trenches about two metres deep, but if there is not enough space in your garden you can install a vertical loop down into the ground to a depth of up to 100 metres for a typical domestic home.
Heat pumps have some impact on the environment as they need electricity to run, but the heat they extract from the ground, the air, or water is constantly being renewed naturally.
Is your garden suitable for a ground loop?
- It doesn't have to be particularly big, but the ground needs to be suitable for digging a trench or a borehole and accessible to digging machinery.
- Is your home well insulated? Since ground source heat pumps work best when producing heat at a lower temperature than traditional boilers, it's essential that your home is insulated and draught-proofed well for the heating system to be effective.
- What fuel will you be replacing? The system will pay for itself much more quickly if it's replacing an electricity or coal heating system. Heat pumps may not be the best option for homes using mains gas.
- What type of heating system will you use? Ground source heat pumps can perform better with underfloor heating systems or warm air heating than with radiator-based systems because of the lower water temperatures required.
- Is the system intended for a new development? Combining the installation with other building work can reduce the cost of installing the system.
Installing a typical system costs around £9,000 to £17,000. Running costs will depend on a number of factors - including the size of your home and how well insulated it is.
How much you can save will depend on what system you use now, as well as what you are replacing it with. Your savings will be affected by:
- Your heat distribution system
If you have the opportunity, underfloor heating can be more efficient than radiators because the water doesn´t need to be so hot. If underfloor heating isn´t possible, use the largest radiators you can. Your installer should be able to advise on this.
- Your fuel costs
You will still have to pay fuel bills with a heat pump because they are powered by electricity, but you will save on the fuel you are replacing. If the fuel you are replacing is expensive you are more likely to make a saving.
- Your old heating system
If your old heating system was inefficient, you are more likely to see lower running costs with a new heat pump.
- Water heating
If the heat pump is providing hot water then this could limit the overall efficiency. You might want to consider solar water heating to provide hot water in the summer and help keep your heat pump efficiency up.
- Using the controls
We can ensure that each area of your property is ‘zoned´ and therefore can be controlled via individual room thermostats. This will ensure the maximum efficiency of your heat pump system is gained.
These are the savings taken from the Energy Saving Trust website that you might make every year when replacing an existing heating system in an average three-bedroom semi-detached home with a typical GSHP installation and a good installation:
|Existing system||Ground source heat pump performing at 250%||Ground source heat pump performing at 300%|
A zero saving means it could cost you just as much to run the heat pump as the system you are replacing. We've assumed average boiler efficiency for each fuel type; heat pumps produce more energy (as heat) than they use (as electricity), so their efficiency is more than 100%.
Heat pump systems typically come with a 10 year warranty. You can expect them to operate for 20 years or more, however they do require regular scheduled maintenance. A yearly check by you and a more detailed check by a professional installer every 3-5 years should be sufficient. The installer should leave written details of any maintenance checks you should undertake to ensure everything is working properly. Consult with your supplier for exact maintenance requirements before you commit to installing a heat pump.
The Ground Source Heat Pump Association say that there is no need for safety checks for ground source heat pumps and that routine maintenance requirements are very low. These may include pre-heating season checks of the water pump, external pipes and fittings and electronics.
In England, Scotland and Wales, domestic ground source heat pumps are generally allowed as permitted developments, but check with your local authority to find out whether you need planning permission or not.
- Danfost Heat Pumps product brochure (1.2 Mb)